ISO INTERNATIONAL STANDARD 14573 Firstedition 2002-05-01 Corrected version 2003-05-15 Snowboard strap bindings for soft boots : Requirements and test methods Fixations de surf des neiges pour chaussures souples --Exigences et methodes d'essai Referencenumber ISO 14573:2002(E) so @ ISO 2002 mitted without license from IHS Not for Resale ISO 14573:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by Iso member bodies. In the unikely event ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or iso's member body in the country of the requester. ISo copyright office Case postale 56· CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mait [email protected] Web www.iso.org Published in Switzerland 中 @ 1sO 2002 - All rights reserved Copyright International Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 14573:2002(E) Contents Page Scope 2 Normative references Terms and definitions .. 4 Parameters 5 Requirements .... 5.1 Function . 5.2 Retaining leash and mounting point for retaining leash ... 3 5.3 Mounting screws 3 Test methods 3 6.1 Apparatus 3 6.2 Sampling . 4 6.3 Loading rate ... 4 6.4Accuracy of measurement 4 6.5 Mechanical testing . 4 6.6 Testing under icy conditions 5 6.7 Testing of fitness for use 5 Marking.. 6 8 Mounting instructions 6 9 Instructions for use 6 1so2002-Allrightsreserved ili