ISO INTERNATIONAL STANDARD 9073-17 First edition 2008-05-15 Textiles Test methods for nonwovens Part 17: Determination of water penetration (spray impact) Textiles-Methodesd'essaipournontissés Partie17:Determination de lapenetration de I'eau (impact d'aerosol) Reference number ISO 9073-17:2008(E) @ISO 2008 ISO9073-17:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is atrademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Casepostale56.CH-1211Geneva20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii Iso2008-Allrights reserved ISO9073-17:2008(E) Contents Page Foreword 1 Scope 2 Normativereferences 3 Terms and definitions.. 4 Principle. 5 Materials and reagents. 6 Apparatus 7 Procedure 8 Calculation 9 Test report. Annex A(informative) General information regarding reproducibility.. @ ISO 2008 - All rights reserved ii ISO9073-17:2008(E) Foreword IsO (the International Organization for Standardization)is a worldwidefederation of national standards bodies non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 9073-17was prepared by Technical Committee ISO/TC 38, Textiles. IsO 9073 consists ofthe following parts,under the general titleTextilesTest methods fornonwovens: Part1:Determination of massperunit area Part 2: Determination of thickness Part 3: Determination of tensile strength and elongation Part 4:Determination of tear resistance Part 5:Resistancetomechanical penetration (ballburstprocedure)1) Part 6: Absorption Part 7: Determination of bending length Part 8: Determination of liquid strike-through time (simulated urine) Part 9:Determination ofdrapability includingdrape coefficient Part 10: Lint and other particles generation in the dry state Part 11: Run-off Part12:Demandabsorbency Part 13: Repeated liquid strike-through time Part14:Coverstockwetback 1)Under preparation. iv @ ISO 2008 - All rights reserved ISO 9073-17:2008(E) Part15:Determinationofairpermeability 一 Part17:Determinationofwaterpenetration (spray impact) test @ ISO 2008 - All rights reserved V INTERNATIONAL STAN