ISO/TS TECHNICAL SPECIFICATION 12927 First edition 1999-12-01 Lubricants, industrial oils and related products (class L) Family M (Metalworking) Guidelines for establishing specifications Lubrifiants, huiles industrielles et produits connexes (classe L)- Famille M (Travail des métaux) Lignes directrices pour I'établissement de spécifications Reference number ISO/TS 12927:1999(E) ISO @ ISO 1999 No r py IHS under itted without license from IHS Not for Resale ISO/TS 12927:1999(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISo Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters @ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ISo1999-All rightsreserved py IHS unde Not for Resale ISO/TS 12927:1999(E) Contents Page Foreword. Introduction 1 Scope 2 Normative references. 3 Explanations of symbols used.. 4 Specificationsguide...... 5 Non-exhaustive lists of characteristics to establish specifications... Annex A (informative) Water-miscible machining fluids. Anti-corrosive properties in contact with non- ferrous metals ... .8 Annex B (informative) Water-miscible machining fluids Evaluation of gumming tendency .. ..12 Annex C (informative) Water-miscible machining fluids Evaluation of the biological stability .. ii by IHS under license with se from IHS Not for Resale